Deep groove ball bearings provide trusted efficiency in a large range of applications and conditions. With super-finished raceways and regulated geometries, our premium style helps make sure constant quality. Our portfolio includes basic, thin section, narrow, broad and miniature and extra-small deep groove ball bearings that cover 3 mm to 400 mm bore sizes. The prolonged line of product consists of a total offering of open, guards, seals and snap ring mixes.
Single-Row Deep Groove Ball Bearings - Pressed Steel Cages
Single-row deep groove ball bearings are the most common type of rolling bearings. Their use is extremely widespread.
In addition to open type bearings, these bearings frequently have steel guards or rubber seals installed on one or both sides and are prelubricated with grease. Likewise, snap rings are in some cases used on the periphery. Regarding cages, pressed steel ones are the most common.
For huge deep groove ball bearings, machined brass cages are used.
Machined cages are also used for high speed applications.

Bonus Small Ball Bearings and Mini Ball Bearings
Additional Small Ball Bearings and Miniature Ball Bearings
Mini and instrument ball bearings can be divided into two standard types, deep groove and angular contact. The very first (deep groove) can be further divided into the following five classes depending on their style information:
Extended inner ring
Expanded type in which one ring has a radial thickness that is larger than regular compared with the bearing width.
Thin area enter which both rings are additional thin in the radial instructions. They can also be categorized as: open, shielded, or sealed.
Maximum-Type Ball Bearings
Maximum-Type ball Bearings contain a larger number of balls than typical deep groove ball bearings because of filling slots in the inner and outer rings. Because of their filling slots, they are not appropriate for applications with high axial loads. BL2 and BL3 types of bearings have boundary measurements equal to those of single-row deep groove ball bearings of Series 62 and 63 respectively. Besides the open type, ZZ type shielded bearings are likewise offered. When using these bearings, it is necessary for the filling slot in the external ring to be beyond the loaded zone as much as possible. Their cages are pushed steel.
Magneto Bearings
The inner groove of magneto bearings is a little shallower than that of deep groove bearings. Considering that the external ring has a shoulder on only one side, the external ring might be eliminated. This is typically beneficial for mounting. In general, 2 such bearings are utilized in duplex pairs. Magneto bearings are small bearings with a bore diameter of 4 to 20 mm and are mainly utilized for small magnetos, gyroscopes, instruments, and so on. Pushed brass cages are normally utilized.